Network Tool Kit - crimping pliers

WB-TK-18

• Moduler plug crimping plier RJ45/12/11 (8P8C/6P6C/4P4C)

• 7.6" length

The design is unique due to light weight and saving energy. When crimping tightly, the gripping force would evenly transfer to all the section(8 or 6 spots)of crimping terminal..Because of reasonable design complied with human being engineering principle .

Non-Ratchet Type:Remove the closed lock to open the handles.

Ratchet Type:Squeeze the handles until it stops to open the handles.

1.Insert cable between stripper blades.

  1a.Insert 4P/6P cble from the top end of the stripper black until it touches the stop guide.

  1b.Insert 8P/10P cable into the two-bladed side of the tool's stripper and let it extend a litter past the lower cut blade.

2.Cutting modular cable:

   Place the single-bladed side of the tool's cutter facing you and cut the modular cable to the desired length.Make sure to cut the ends of the cord straight across, not diagonally.

3.Squeeze handles until it stops, cable must be kept perpendicular and then pull from the tool.

4.Remove the outer jacket ,insert the stripped cable into the plug and be sure the left wire at one end matches the right wire at the other end.

5.Place modular plug with cable into the tool's holder.Make sure the stripped wire is between the tab and gold contacts. Squeeze handles until it stops.

6.Remove the crimped plug from the tool.

7.During the crimping process, you may turn the screw on the ratchet in counterclockwise direction to stop the incorrect operation.

8.To crimp "DEC"plug, follow step1 to step4.

   Remove the screw on the left side of the 6P holder, insert the "DEC" plug and cable into the 6P holder and squeeze handles till it stops.